What work should be done when the wire mesh loom is turned on?

Wire mesh weaving machine is a kind of low carbon steel wire, stainless steel wire, aluminum alloy wire, PVC wire, plastic-coated wire hook knitting and hook mesh, with uniform mesh, flat mesh surface, beautiful and generous, net width and width can be adjusted, wire diameter thickness can be adjusted, not easy to corrosion long life, weaving simple, beautiful and practical characteristics.
The metal mesh loom has the characteristics of high production efficiency and stable mechanical properties. The use of well-known brand servo system, so that the failure rate is greatly reduced, the performance tends to be stable, and the cutting position is more accurate. Reducer part: precision planetary reducer integrated machine, high durability, low noise.
Main work and matters needing attention when starting up the wire mesh loom
1. Open the main water supply pipeline before starting the wire mesh machine, drain the water first, and prevent the residual sewage in the pipeline from entering the water tank, pump body and nozzle.
2. Wet the warp thread at the weaving mouth, reed and heald with water again, soften the residual stock, and avoid the residual hard pulp block that will be pulled and broken by the wire when driving directly.
3. Connect the power supply of the wire braiding machine, plug in the line control board, open the water supply valve of the water tank, test the power and water, and observe whether the water and electricity are normal.
4. Adjust the tension of the warp wire well, and rotate the spindle dial by hand to check whether the injection, filling and heeling are normal.
5, if you need to change the variety and specifications of green silk, you can replace the good weft wire and the appropriate let-off and winding gear, change the weft density.
6, if the metal wire mesh loom reed heald at the pulp is serious, resulting in warp wool, etc., you can manually shake the warp wire through the knitting mouth a few centimeters to ten centimeters, depending on the specific situation, and then try driving.
7, if the above main work is done, check that everything is normal, you can start the operation according to the normal procedure.